Lit. No. 43826, Rev. 01
21
September 15, 2014
MODELS SP-575 AND SP-1075
TROUBLESHOOTING
Spreader
does not run.
Control turns on,
beeps, shuts off,
displays error code.
ON/OFF switch
lights no display
Nothing happens,
no display,
ON/OFF
will not light up
OL code
E1 code
LB code
All other codes
EO code
Check input power.
Check power
source to control.
Defi nition:
Amp draw too high
Defi nition:
Dead short in
motor circuit
Defi nition:
Bad electrical
connection
Check harness
for spliced-in
accessory.
Defi nition:
Open circuit
between motor
and control
Bad control;
contact distributor.
Defi niton:
Low battery, less
than 12V output
Bad control;
contact distributor.
Jammed material
Corrosion
Break in wiring
harness; contact
distributor.
Replace affected
components.
Bad motor;
contact distributor.
Bad control;
contact distributor.
Corrosion
Bad control;
contact distributor.
Spreader
unplugged
Loose connection,
bad ground
Bad transmission;
contact distributor.
Motor power cord
disconnected
inside drive assy.
Load test battery.
Clear jam.
Replace all
corroded
connections.
Replace harness.
Replace all
corroded
connections.
Plug in spreader.
Tighten or replace
Turn shaft by hand;
should turn freely.
Open access cover
and plug together.
Apply dielectric
grease.
4- to 20-amp draw,
no load — good
20+ amp draw,
no load — bad
Содержание SP-1075X
Страница 2: ......
