Lit. No. 43828, Rev. 02
18
January 15, 2019
CAB CONTROL
Starting and Stopping the Motor
To start the spreader, press the control POWER
switch to the "ON" position.
Press the POWER switch to the "OFF" position to stop
the spreader.
NOTE: The truck ignition must be ON to start the
spreader.
NOTE: If truck ignition is turned OFF while
spreader is running, the motors will stop.
Adjusting Auger/Spinner Speed
Speed of auger and spinner can be adjusted
separately to get desired
fl
ow and spread distance.
Turn the speed dial clockwise to increase speed.
When the POWER switch is set to the "ON" position,
the spreader will accelerate to the speed set on the
dial.
Turn the speed dial counterclockwise to decrease
speed.
OPERATING THE SPREADER
Vibrator
ON/OFF Switch
Spinner Speed
Dial
Power ON/OFF
Switch
Auger Speed
Dial
Display
WARNING
Never operate equipment when under the
in
fl
uence of alcohol, drugs, or medications that
might alter your judgment and/or reaction time.
WARNING
Never allow children to operate or climb on
equipment.
WARNING
Never exceed 45 mph (72 km/h) when loaded
spreader is attached to vehicle. Braking
distances may be increased and handling
characteristics may be impaired at speeds
above 45 mph (72 km/h).
WARNING
Before starting the spreader, the driver shall
verify that all bystanders are a minimum of
25 feet away from operating spreader.