SNOWDOG Long Track B13 MER, Руководство пользователя

Страница: 14 / 24

14
8.5.1 Sliders installation (if provided)
1. Loosen the track.
2. Unscrew and remove the central bogie (if provided).
3. Remove the plugs (3) from the wheels.
4. Install the axle (4) inside the bogie.
5. Install the bushings (5) and (6) on the axle.
6. Install the sliders (7) .
7. Install the washers (8) and the nuts (9) . Tighten the
nuts.
8. Install and unbend the pins (10) .
8.6 CVT belt
!
Warning
All the works on the CVT should be carried out
only with the stopped engine.
Carefully inspect the CVT. Clean up, if necessary.
Check the condition and availability of plastic inserts after
each case of use. Lubricate the working surface, if necessary.
If plastic inserts are missing or worn out — install new ones.
Lubricate the inserts (1) and the CVT shaft (2) every month.
8.6.1 CVT belt removal
1. Stop the engine.
2. Lift the hood and provide free access to the CVT.
3. Pull the part of the belt off to the external side of
the driven pulley of the CVT.
3
5
4
8
10
9
7
6
1
2
4. Rotate the driven pulley and guide the belt to its
external side.
5. After the belt is completely off the driven pulley of
the CVT, take it off the driving pulley.
8.6.2 CVT belt installation
1. Put the belt on the driving pulley of the CVT.
2. Put a part of the belt on the driven pulley of the CVT.
3. Rotate the driven pulley and guide the belt to the
working part of the pulley.
8.7 Air filter
The air filter body is fixed on the carburetor.
The filter element is located under the air filter cap.
To take the filter cap off, simply unscrew the wing nut.
When you install and uninstall the filter cap, pay attention
to the condition of the air filter. If there are contaminations
on the filter, it needs to be cleaned or replaced. If there is ice
or snow on the filter, it needs to be dried.