Snow Peak TW-800, Инструкция по эксплуатации

Страница: 6 / 8

1) Install the Rubber Seal Correctly.
Mount the rubber seal as shown in the figure. If the rubber seal is not installed properly, the drink may
leak and damage nearby items.
2) Adding Liquids.
Please follow the guideline below when filling the bottle.
3) Close the cap.
Tighten the cap until it stops rotating, and check that there
is no water leakage. If the cap is not tightened properly, the
drink may leak and cause physical damage.
4) Wash.
Please wash the product thoroughly after use. Follow the
maintenance instructions below.
2
〈 from the bottom 〉
Install it so the seal
forms a concentric
circle without distortion.
Cross-section view
Press Press
If there is a
distortion, the drink
may leak.
Liquid
Bottle
How to Use
CAUTION / Misuse could result in injury to the user and/or property damage.
●Please wash this product well before using it for the first time, as oil may remain from the manufac -
turing process. ●Due to the single-wall structure, hot liquids easily transfer heat to the surface of the
bottle. Do not use the bottle with hot drinks over 40 ℃(104 ℉ ). ●When opening the cap, keep it
horizontal, do not shake and open slowly. The contents may leak and lead to property damage. ●Do
not boil the bottle or the cap, and do not put them in a dishwasher or dryer. The bottle and cap may
be deformed due to heat, resulting in leaks and potential stains. ●Do not use this product for anything
other than carrying drinks. ●Before carrying a drink in this product, please turn the bottle upside down
and check for leaks. ●Please note: if you repeatedly use this product with coffee or tea, the inside of
the bottle or rubber seal may change color. ●Due to the product’s structure, filling with cold drinks will
result in condensation on the outer surface. The temperature difference between the liquid and the
outside air causes condensation. Use caution to avoid damaging surrounding items by getting them
wet. ●If you plan not to use the product for a long time, loosen the cap before storing it to protect the
rubber seal. ●Do not put drinks in this product and freeze it. Freezing drinks may cause the bottle to
burst. ●If the drink's temperature drops, the internal pressure may decrease, making the cap difficult
to open. If the cap does not open, running hot water over the outside of the bottle may help. ●Please
avoid putting strong acidic or alkaline liquids in this bottle. Do not leave liquids in the bottle for long
periods, as corrosion or discoloration may occur. ●If using this product for sports drinks, please wash
the bottle immediately after use. Rinse the inside of the bottle with water if you are out and cannot
use soap. Failure to clean appropriately may cause mold or rust. ●Avoid shocks or jolts from falling,
dropping, or hitting. Shocks to the product may cause damage, rust, peeling of the coating, or leaks.
●Please break ice cubes into smaller pieces before putting them into the bottle. ●Do not leave the
product’s outer surface wet, as rust, odor, or dirt may accumulate.