280cm Wing Pole
240cm Wing Pole
Red Tape
Black Tape
Roof Sheet Tape
Tip of Wing Pole
Triangle Bracket
How to attach the ropes at main corner.
Hang the center loop to the tip of the wing pole, then twist it once, and hang it again.
Peg Down
End
Section
Center Loop
A
A
A
B
B
B
B
B
Set Up Procedure
Make sure that two or more people take part in the set-up for safety.
Spread the tarp on the ground.
Lay the tarp out in a folded state on the flat place where setup will take place (see figure below). Set up
the tarp while considering the wind direction and layout. At this time, the wing pole should also be placed
with its tip on the tarp side, aligned with the ridgeline of the tarp. Place a 280 cm wing pole on the side with
the red tape and a 240 cm wing pole on the side with the black tape.
1
Attach the rope.
Insert the tip of the wing
pole into the triangle
bracket at the main
corner, and hang a center
loop of the forked 10m
rope from above. (2
positions) After that,
extend the rope toward
the wing pole by 45°C
and extend the end of the
rope to the position where
the lower end of the wing
pole is aligned, then peg
down the end section.
3
Attach the roof sheet tape and the triangle
bracket of the tarp to the wing pole.
Insert the tip of the wing pole in the order of the roof
sheet tape grommet and the triangle bracket.
* Make sure that the roof sheet tape (red/black) and
the triangle bracket tape (red/black) match in color.
2
5
Follow the instructions below for setup and removal so you’re prepared to use the tarp in camp. Ensure all the
accessories are included in the package. Forcible installation or removal may result in damage to the main unit
or frames, or an accident. Please read thoroughly to understand the instructions.
Note
Before installation, make sure the roof sheet tape is
not frayed or deteriorated.
Approx. 45°
Approx. 45°
Approx. 45°
Approx. 45°