Snorkel SL30SL, Руководство по эксплуатации

Страница: 17 / 64

Chapter 4 – Safety Devices
SL30SL – 8210037 13
Danger
The aerial platform can tip over if it becomes unstable.
Death or serious injury will result from a tip-over
accident. Do not drive or position the aerial platform
for elevated use near any drop-off, hole, slope, soft
or uneven ground, or other tip-over hazard.
The aerial platform must be on a firm, flat surface capa -
ble of withstanding the load forces imposed by the aerial
platform in all operating conditions before the speed
level is used.
Engine Protection Systems
A constant alarm will sound to warn against high engine
temperature or low oil pressure.
The engine will shut-down
y
if the operating temperature exceeds a preset level
y
or if the oil pressure is too low for safe operation.
High Engine Temperature Alarm
If the coolant exceeds the engine operating temperature
an alarm will sound and the engine will shut off.
Do not restart the engine until the condition that caused
the overheating has been corrected.
Low Oil Pressure Alarm
The low oil pressure alarm sounds when the engine oil
pressure is near the lower limit for safe engine operation.
If the alarm sounds, lower the platform to the ground and
then turn the engine off.
y
If the engine oil pressure falls below a safe operating
value the engine will shut off.
y
The engine can be restarted with low oil pressure,
but it will only run for a few seconds before it shuts
off again.
y
Do not restart the engine until the condition that
caused the low oil pressure has been corrected.
Horn Button
The horn button may be used to warn personnel on the
ground. The horn button is located on the upper control
panel (refer to Figure 4.6).
Lowering Alarm
When the aerial platform is lowered, the alarm emits a
loud beeping sound to warn personnel in the work area
to stand clear.
Danger
Pinch points exist on the machine. Death or serious
injury will result if the platform lowers onto personnel.
Stand clear while raising and lowering the platform.
Be careful when lowering the platform. Keep hands and
fingers away from the machine components.
All Motion Alarm
An optional all motion alarm may be provided on the
machine. The alarm sounds, in short beeps, anytime the
machine functions are being operated. The alarm is used
to warm personnel in the work area to stand clear.
Flashing Light
The optional flashing light mounted on the machine may
be used to warn personnel that the aerial platform is in
the area.
The lights flash at about one flash per second when the
engine is running.