Snorkel S2632E, Руководство по запасным частям

Страница: 137 / 154

S2632E – 1420331 Maintenance – 15
Lubrication Points
8
10
2
5
4
Lubrication
Specific lubricants as recommended by Snorkel, should
be used in maintaining the unit. If in doubt regarding
the use of lubricants other than those listed, contact
Snorkel Customer Service Department for evaluation
and recommendation.
Anytime the aerial platform is elevated to perform
maintenance work, properly position the safety prop as
outlined on the safety prop decal.
Danger
Pinch points exist on the scissors structure. Death
or serious injury will result if the scissors structure
drops onto personnel working within the scissors
arms or under the raised platform. Properly posi-
tion the safety prop before reaching through the
scissors structure.
Refer to the above lubrication illustration for location of
item numbers.
Service all lubrication points as indicated in the Mainte -
nance Schedule and lubrication illustration. Wipe away all
excess lubricant from exposed surfaces. Over lubrication
can collect dirt and foreign matter which acts as an abra -
sive. Lubrication of accessory equipment should be in
accordance with the manufacturer’s recommendations.
Tie Rods
Tie rods – Item 1. Lubricate using a petroleum based
spray lubricant following the Frequent Inspection and
Maintenance schedule.
King Pins
King pins – Item 2. Lubricate using a grease gun with
an extreme-pressure multipurpose grease following the
Frequent Inspection and Maintenance schedule.
Steer Cylinder Ends
Steer cylinder ends – Item 3. Lubricate using a petroleum
based spray lubricant following the Frequent Inspection
and Maintenance schedule.
Rear Wheel Bearings
Rear wheel bearings – Item 4. Clean and repack the
rear wheel bearings following the Annual Maintenance
schedule.
Clean and repack the bearings following normal auto -
motive procedures.
Note
The front or drive wheel bearings are sealed and do not
require lubrication.
Pothole Protectors
Pothole protectors – Item 5. Lubricate using a petroleum
based spray lubricant following the Frequent Inspection
and Maintenance schedule.
After lubricating, remove any excess so it will not collect
dirt and debris.
Hydraulic Oil Reservoir
Hydraulic oil reservoir – Item 6. The fluid level should
be kept level with the indicator line on the side of the
reservoir and should be checked with all cylinders fully
retracted.
7 6 5 8
1,3
9
10
4
11 5 8
5