SECTION 0
HD22OP271100 Version 1 Issue 1
0.2
Explanation of Safety Symbols
This symbol refers the user to important information contained in the accompanying literature.
Refer to manual.
This symbol indicates that hazardous voltages are present inside. No user serviceable parts
inside. This unit should only be serviced by trained personnel.
Safety Warnings
WARNING
TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT EXPOSE THIS APPLIANCE TO
RAIN OR MOISTURE.
•
Always ensure that the unit is properly earthed and power connections correctly made.
•
This equipment must be supplied from a power system providing a PROTECTIVE EARTH
connection and having a neutral connection which can be reliably identified.
•
The power outlet supplying power to the unit should be close to the unit and easily accessible
Lithium Batteries
The HD2200 contains two Lithium batteries to provide non-volatile memory. Used batteries should only be
disposed according to the manufacturers instructions. The batteries are located at the front left-hand edge of
the upper circuit board (HIO), just behind the left card edge ejector.
Power cable supplied for the USA
The equipment is shipped with a power cord with a standard IEC molded free socket on one end and a
standard 3-pin plug on the other. If you are required to remove the molded mains supply plug, dispose of the
plug immediately in a safe manner. The color code for the lead is as follows:
GREEN lead connected to E (Protective Earth
Conductor)
WHITE lead connected to N (Neutral Conductor)
BLACK lead connected to L (Live Conductor)
Servicing instructions, where given are for use by qualified
service personnel only. To reduce risk of electric shock do not
perform any servicing other than that contained in the operating
instructions unless you are qualified to do so. Refer all servicing to
qualified personnel.
CAUTION
This equipment contains a lithium battery
There is a danger of explosion if this is replaced incorrectly
Replace only with the same, or equivalent type.
Dispose of used batteries according to the
manufacturers instructions.
Batteries
shall only
be replaced by trained service
technicians
