Snapper YARD CRUISER YZ145332BVE, Инструкции по безопасности и руководство оператора, Страница: 16 / 32

16
Section 4 - ADJUSTMENTS & REPAIR
WARNING
DO NOT attempt any adjustments, maintenance,
service or repairs with the engine running. Stop engine.
Stop blade. Engage parking brake. Remove key.
Remove spark plug wire from spark plug and secure
away from plug. Engine and components are HOT.
Avoid serious burns, allow all parts to cool before
working on machine. Fuel Filler Cap and Vent must be
closed securely to prevent fuel spillage.
4.3.4. BELT REPLACEMENT
(Continued From Previous)
2. Route belt around stationary idler.
3. Remove spring that is connected to idler pulley.
Loosen nut and bolt that secures idler pulley to idler
arm. Route belt between belt guide and idler pulley.
4. Route belt onto spindle pulley. Make sure belt is
inside spindle pulley belt guide.
5. Reinstall idler pulley spring. See Figure 4.4.
NOTE: The idler belt guide should be positioned so
the locator tab fits into the corresponding hole found
on the idler arm. See Figure 4.4. Tighten bolt
securely.
6. Reinstall front frame cover.
BELT REPLACEMENTS
Engine to Hydro Pumps (All Models) Part No. 4-1823
Engine to Electric Clutch (All Models) Part No. 2-9117
Electric Clutch to Mower (33” Decks) Part No. 3-5389
Electric Clutch to Mower (38” Decks) Part No. 2-9308
FIGURE 4.4
4.3.5. BLADE BRAKE
The blade switch engages the electric clutch when
pulled out to the “ON” position. When the blade switch
is in the “ON” position the cutting blade(s) are
engaged. The blade switch disengages the electric
clutch when the blade switch is pushed in to the “OFF”
position. When the blade switch is in the “OFF”
position the cutting blade(s) are disengaged. The
electric clutch is non-adjustable. The blade(s) should
stop rotation in 5 seconds or less. If the electric clutch
fails to stop the blade(s) rotation in 5 seconds, contact
an authorized SNAPPER dealer to repair or replace.
WARNING
Blades must stop rotating in 5 seconds or less after
blades have been turned off. DO NOT operate
machine until blade brake has been repaired and
functioning properly. Contact your SNAPPER dealer
for assistance.
4.3.6. ADJUSTING MOWER BLADE
The straightness of the mower blade(s) is essential for
smooth, even mowing. Adjust blade straightness as
follows. NOTE: Follow Steps 1 thru 4 for all deck
sizes.
1. Make sure fuel cap is on tight. Turn fuel shut off
valve (If equipped) to the “CLOSED” position. Start
engine and allow it to run until engine runs out of
fuel. Close vent on fuel filler cap. See Figure 2.3.
2. Remove key from ignition switch.
3. Remove spark plug wire(s) and secure away from
spark plug(s).
4. Carefully stand YARD CRUISER on rear bumper.
(Continued On Next Page)
IDLER ARM AND BELT
GUIDE DETAIL
TAB MUST GO
INTO HOLE
LOCATOR
TAB
BELT
GUIDE
MOWER
BELT
STATIONARY
PULLEY
BELT
GUIDE
IDLER
ARM