Snapper WLT180H42IBV2, Инструкции по безопасности и руководство оператора

Страница: 19 / 48

19
Section 4 – ADJUSTMENT & REPAIR
WARNING
DO NOT attempt any adjustments, maintenance or
service with the engine or blades running. STOP
blades. STOP engine. Set brake. Remove key.
Remove spark plug wire from spark plug and secure
wire away from spark plug. Engine and components
can be extremely hot. Avoid burns by allowing engine
and components sufficient time to cool.
4.2.3. MOWER DECK ADJUSTMENT (LEVELNESS)
1. SIDE-To-SIDE (42” Decks)
j. Reconnect sector plates, remove angle iron,
pipe, etc. and recheck side to side level. Adjust as
needed to result in blade tips being within 1/8” of
the same distance from the floor.
k. Proceed to check front to rear deck pitch.
FIGURE 4.3
4.2.4. MOWER DECK ADJUSTMENT (LEVELNESS)
FRONT-To-REAR
(42” Decks)
1. Remove hair pins and washers securing sector
plates to rear lift arms. See Figure 4.4.
2. Move sector plate as required to raise or lower the
rear of deck.
NOTE: The deck should be set so that the rear of the deck
is 1/4” lower than the front.
3. If the sector plates are in their lowest setting and
proper level cannot be obtained, adjust the front lift rod
as follows:
4. Move deck lift lever to #5 position.
5. Place a 2 x 4 wooden block on edge under front
center of deck.
6. Place a 3 x 3 wooden block under rear center of
deck.
7. Remove hair pins and washers securing sector
plates. Lower rear of deck onto 3 x 3 block.
8. Remove hair pin and washer securing front lift
cable to front lift arm. See Figure 4.5.
FIGURE 4.4
FIGURE 4.5
9. Remove front lift cable and rest front of deck onto
2 x 4 block.
10. Loosen jam nut on front lift cable. See Figure 4.5.
11. Rotate front lift cable until it can be reinstalled into
front lift arm without lifting deck.
12. Secure lift cable to lift arm with washer and hair pin.
Secure jam nut.
13. Reinstall sector plates onto rear hanger brackets
and secure with washers and hair pins.
14. Raise deck and remove wooden blocks.
15. Repeat steps for front to rear level until levelness
is acquired.
SECTOR PLATES
HIGHEST DECK
SETTING
REMOVE HAIR PIN
& WASHER
LOWEST DECK
SETTING
FRONT LIFT ROD
WASHER
HAIR PIN
JAM NUT
FRONT LIFT CABLE
CLEVIS
PIN
FRONT LIFT ROD
HANGER
LOOSEN
PIVOT
BOLT
LOOSEN
SHOULDER
BOLT
TURN ECCENTRIC
AS REQUIRED