Snapper SCRAMBLER YZ18426BVE, Инструкции по безопасности и руководство оператора

Страница: 18 / 36

18
Section 4 - ADJUSTMENTS & REPAIR
WARNING
DO NOT attempt any adjustments, maintenance or
service with the engine or blade running. STOP
blade. STOP engine. Set brake. Remove key.
Remove spark plug wire from spark plug and secure
wire away from spark plug. Engine and components
can be extremely hot. Avoid burns by allowing
engine and components sufficient time to cool.
4.2.6. MOWER DECK ADJUSTMENT (LEVELNESS)
Side-To-Side (48” Decks)
(Continued From Previous Page)
4. Remove hair pin from pivot rod and pull rod
out of lift arm.
5. Rotate pivot rod up or down to achieve the
proper levelness. See Figure 4.5.
6. Reinstall hair pin into pivot rod.
7. Reinstall footrest/floor pan assembly.
FIGURE 4.5
4.2.7. MOWER DECK ADJUSTMENT (LEVELNESS)
Front to Rear Deck Pitch (48” Deck)
Before making deck leveling adjustments, check the
tire pressure. Add or release air as needed to bring
pressure to 12 P.S.I. in front and 12 P.S.I. in rear tires. If
tires are properly inflated and mowing is still uneven,
check side-to-side deck levelness first then proceed
to front to rear adjustment. Adjust front to rear deck
levelness as follows:
1. Place SCRAMBLER on a smooth level
surface.
2. Remove footrest/floor pan assembly.
3. Rotate outside blades so tips are pointed to the
front and rear of deck. Measure the distance from
blade tips to floor. The distance should be the
same, or the rear 1/4” higher than the front. If the
rear blade tip is lower or is more than 1/4” higher
than the front, proceed to Step 4 for adjustment.
4. Remove the hair pin from pivot rod on one side
of deck at a time.
5. Rotate each pivot rod up or down the same
number of turns to achieve the proper levelness.
6. Reinstall both hair pins into pivot rods. See
Figure 4.5.
7. Reinstall footrest/floor pan assembly.
4.2.8. MOWER DECK TIMING ROD - 48” DECKS
The mower deck timing rod is preadjusted at the
factory. It is set to maintain the deck in the same
attitude through all heights of cut. If the timing rod
requires adjustment, contact an authorized
SNAPPER dealer for service.
HAIRPIN
LIFT ARM
PIVOT ROD