8
Section 2 - OPERATING INSTRUCTIONS
WARNING
DO NOT attempt any maintenance, adjustments or
service with engine and blade running. STOP engine
and blade. Disconnect spark plug wire and secure
away from spark plug. Engine and components are
HOT. Avoid serious burns, allow sufficient time for all
components to cool.
2.6 RECYCLING
OPERATION
NOTE: For best recycling results, cut up to a maximum of
1/3 of grass blade length and recycle ONLY when grass is
dry.
1. Set all wheels in the highest cutting position
(Notch 6).
2. Move engine speed control to “FAST” (Rabbit)
position.
3. Move ground speed control to slowest speed
setting.
4. Proceed mowing slowly. If grass is very dense,
lower each rear wheel latch one notch lower than
the front wheel latches to improve recycling
performance.
2.7 ADJUSTING FRONT DECK BAFFLE
The front of the cutting deck on these models has
been modified with an open area. This allows the
blade to have more direct contact with the grass and
allows more air flow into deck chamber. The
adjustable baffle should be secured in the lowest
position when using a grass bag. The baffle should
be secured in the highest position when mulching
grass.
NOTE: Under certain conditions, when mulching, some
grass may blow out from under front of baffle. This is
normal but, the amount of grass blowing out can be
reduced. Lower baffle slightly to reduce the amount of
grass blow out.
1. Stop engine. See WARNING above.
2. Loosen wing nuts that secure front deck baffle.
See Figure 2.9.
3. Lower the adjustable baffle to the lowest position
when using a grass bag. Raise the baffle to its
highest position when mulching grass. Take care to
keep the baffle’s lower edge parallel to the bottom of
the deck. See Figure 2.9.
4. Retighten wing nuts securely.
2.8 INSTALLATION of GRASS CATCHER
(Optional accessory on some models)
Install grass catcher by sliding connector over flange of
adapter. Attach grass bag hooks over middle handle
cross bar. See Figure 2.10.
FIGURE 2.9
WARNING
DO NOT operate without entire Grass Catcher or
guard in place. Grass Catcher components are
subject to deterioration during normal use. Inspect
frequently and replace worn or damaged components
immediately.
FIGURE 2.10
HOLE DESIGNATES TOP OF
BAFFLE (ALWAYS KEEP
HOLE IN UP POSITION)
FRONT DECK BAFFLE (SHOWN
IN HIGHEST POSITION)
FRONT
DECK
BAFFLE
WING
NUTS
MOVE BAFFLE UP FOR
MULCHING GRASS
MOVE BAFFLE DOWN
FOR GRASS BAGGING
FRONT CUTOUT OF DECK
WING NUT
