Snapper CP215019KW, CP215519HV, Инструкции по безопасности и руководство оператора

Страница: 9 / 32

9
Section 2 - OPERATING INSTRUCTIONS
2. Set all wheels at the same cutting height. The
highest cutting position is Notch 7. The lowest
cutting position is Notch 1. See Figures 2.7 & 2.8.
FIGURE 2.8
2.6 INSTALLATION of GRASS BAG ADAPTER
WARNING
DO NOT attempt any maintenance, adjustments or
service with engine and blade running. STOP engine
and blade. Disconnect spark plug wire and secure
away from spark plug. Engine and components are
HOT. Avoid serious burns, allow sufficient time for
all components to cool.
STEP 1:
Install the grass bag adapter and secure to the
side and top of the deck with the two nuts provided on the
machine. Slot in front edge of adapter must be under nut
located on top of deck. See Figure 2.9.
FIGURE 2.9
STEP 1a (Kawasaki only):
Attach Bag Adapter Standoff
between rope guide pulley assembly and engine recoil.
See Figure 2.10.
A. Remove right rear bolt from engine recoil cover.
B. Remove torx screw and nut securing rope guide
pulley to bracket on bag adapter.
C. Lay standoff between bolt holes in engine recoil
cover and bag adapter pulley bracket. NOTE:
position standoff so that bent end is toward engine
recoil cover.
D. Flip pulley over so that flange of steel bushing is
under pulley. (The bushing will act as a washer
between the pulley and standoff.)
E. Reassemble pulley to bag adapter, and install
supplied replacement bolt, fitted with thread sleeve,
into recoil cover. Tighten all hardware securely.
FIGURE 2.10
STEP 2:
Route recoil rope around recoil rope pulley on
bag adapter. See Figure 2.10. NOTE: Pulling Blade
control against upper handle will allow extra recoil slack.
2.7 INSTALLATION of RECYCLING PLUG
(Optional Accessory on Some Models)
STEP 1:
Once adapter has been installed, recycling may
be desired. Insert recycling plug completely and securely
into adapter. See Figure 2.11. Install grass bag as a
safeguard.
FIGURE 2.11
STEP 2:
Refer to Section “OPERATING
INSTRUCTIONS – RECYCLING OPERATION”.
LATCH
POSITION
CUTTING HEIGHT SETTINGS
SECURE ADAPTER
TO DECK WITH NUTS
SECURE
WITH NUTS
ADAPTER
INSERT RECYCLING PLUG
COMPLETELY AND SECURELY
INTO ADAPTER. INSTALL
GRASS BAG.
ADAPTER
PLUG
REPLACEMENT
BOLT WITH
THREAD SLEEVE
BEND
STANDOFF
ROPE GUIDE PULLEY
RECOIL