4
STEP 9:
Insert the bag rod (item 4, see page 6) into the
upper loop of the grass catcher bag (Item 5, see page 6)
and work the grass bag until completely around the bag
rod. The opening should be positioned at the bag rod
opening. Push the bag rod connector (item 12, see page
6) over one end of the bag rod. Push the bag rod
connector onto the rod until half of the connector is over
the end of the rod. Position bag/rod assembly vertically
and place foot on the inside of the bottom section. Lift
the upper corner of the bag/rod assembly and guide the
other end of the rod into the connector. See Figure 9.
Work the rod ends together until they meet. Slide grass
bag/rod into frame with open mesh to the rear of mower.
Secure in place with latch.
FIGURE 9
STEP 10:
Slip top end of grass tube into the container
top. Push backward until handle end clears the end of
the chute adapter. Then slide the grass tube over the
adapter opening and turn grass tube until handle base
end catches under the tube latch on adapter. See
Figure 10.
FIGURE 10
STEP 11: WEIGHT PLATE INSTALLATION (REAR
ENGINE RIDER ONLY)
IMPORTANT:
Some model Riders may require the two
mounting holes to be drilled in the front frame. See Step 12
for drilling instructions. The mounting holes in other models
may be covered by the SNAPPER label.
Attach the six weights to the front frame using 3/8-16 x 2-
1/4” hex cap screws, flat washers, 3/8” split lock washers
and 3/8-16 hex nuts. Tighten nuts and bolts securely. See
Figure 11.
FIGURE 11
WARNING
Weight Plates must be installed before operating the
machine with a grass catcher kit. Grass catchers
and other attachments affect the handling and
stability of the machine. Use extra care. Refer to the
Operator’s Manual for IMPORTANT SAFETY
INSTRUCTIONS
STEP 12 DRILL MOUNTING HOLES (SERIES M
RIDERS ONLY)
Measure and mark the location of the two holes using
dimensions shown. See Figure 12. Drill two 13/32”
holes. Attach weight plates. Refer to Step 11.
FIGURE 12
BAG ROD
CONNECTOR
TUBE LATCH
GRASS TUBE
ADAPTER
PLACE HEAVY
WASHER ON
BOLT
