19
Initial Setup & Assembly
A
B
C
Figure 19. Upper Wiring Harness
A. Switch
B. Female Receptacle
C. Rotation Motor Power Leads
A
B
C
D
Figure 20. Wiring Harness Connections
A. Upper Wiring Harness
B. Final Wiring Harness.
C. Mounting Clip
D. Chute Rotation Motor Connection
ATTACHING CHUTE MOTOR
WIRING HARNESS
1. Wiring Harness is in four (4) parts.
a.
Switch
b.
Upper wiring harness with main power connector
c.
Final wiring harness with a square connector on
each end.
2. Remove plug from tractor control panel at position
shown and install the chute rotation switch
(A, Figure 19).
3. Plug female receptacle (B, Figure 19) end of the
upper wiring harness onto switch.
4. Route the upper wiring harness (B, Figure 19) down
through the right side of the panel enclosure, locating
the square connector in front of the firewall, along the
tractor frame.
5. Locate the power leads (Red with yellow stripe and
black) in the tractor wiring harness at the base of
steering column. Connect the wiring harness power
leads (B, Figure 20), color to color, to the chute rota-
tion wiring harness spade connectors.
6. Connect the final wiring harness (B, Figure 20) to the
upper wiring harness (A) using the square connector
and then to the chute rotation motor connector (D).
Position the wiring heat cover underneath the tractors
muffler. Loosely secure the final wire harness (B) to
the lift arm linkage (C, Figure 23)
Install Reflectors
1. Install the two reflectors on the rear of the tractor seat
deck.
