Snapper 1694403, Руководство оператора

Страница: 17 / 24

15
Initial Installation
Assemble Discharge Chute
1. Remove the three hold downs (B, Figure 17) and
plastite screws (A).
2. Lubricate the base of the discharge chute and ring
gear with automotive lithium grease.
3. Remove the plastic cover (B, FIgure 18) and loosen
the three taptite screws (A) securing the electric
spout rotator motor.
4. Install the discharge chute and secure to the chute
ring (C, Figure 17) using the three hold downs (B)
and plastite screws (A).
5. Adjust the motor so that it meshes with the discharge
chute ring gear and tighten the adjustment screws (A,
Figure 18).
Install Skid Shoes
1. Install the skid shoes using 3/8-16 x 3/4” carriage
bolts, washers, lockwashers, and nuts as shown in
Figure 19.
2. Adjust the skid shoes. See Adjustments section.
Electric Chute Rotator Gear
1. Remove the plastic cover (B, Figure 18) and loosen
the three taptite screws (A) securing the electric
spout rotator motor.
Figure 17. Assemble Discharge Chute
A. Plastite Screw
B. Hold-Down
C. Chute Ring
Figure 18. Discharge Chute Motor Adjustment
A. Adjustment Screws
B. Plastic Cover
Figure 19. Skid Shoe Installation
A. Carriage Bolt, 3/8-16 x 3/4”
B. Snowthrower Housing
C. Skid Shoe
D. Washer
E. Lockwasher
F. Hex Nut
A
B
C
D
E
F
A
B
A
A
B
C
2. Adjust the motor so that it meshes with the discharge
chute ring gear and tighten the adjustment screws
(A).
Attach Deflector Control Cable Support Arm
1. Assemble the deflector control cable support arm (A,
Figure 22) to the left side of the snowthrower using
one 5/16-18 x 1” capscrew, lockwasher, and nut
using the holes (B) shown in Figure 22.