20
Possible Causes
•
The cable connector for one of the motor cut-off switches is not properly connected or
loose
•
The motor cut-off switch wiring is damaged
•
One of the brake levers is not returned to its original position (due to a faulty spring or
other factors)
•
One of the motor cut-off switches is faulty
•
Caused by the brakes being used while the LCD screen is being turned on. While
powering up the LCD screen make sure the brakes are not touched and in their upright
position.
What should I do
:
When this error appears, turn off your LCD screen. Check if the brake levers are all returned to its
original position, ensure the connectors for the motor cut-off switches are properly connected, and
do not touch any brake lever, when you turn on your LCD screen again.
If this error persists, you may need to get your motor cut-off switches or the associated cables
replaced.
6.6 Error Code 0x30
Definition
: This error means loss of communication between the controller and the LCD screen.
Possible Causes
•
Loose connection between the controller and LCD.
•
Faulty LCD
•
Faulty controller.
What should I do
:
Check if the connectors between the LCD and the controller are properly connected. Unplug the
connectors, and plug them back, then turn on the LCD screen to see if the error persists.
Check if the cable between the LCD and the controller has visible damage
If the problem persists, you can contact Snapcycle Customer Support team via email
at
