Snap-On TECHANGLE, Руководство пользователя

Страница: 7 / 120

6
Note: Head length entered is offset length measured from center of drive to center of fastener.
Use of Negative Offsets
Note: Enter a negative value for offset when used in reverse direction.
When length of an offset is negative, maximum fastener target is limited by following formulas:
240 in-lb wrench:
Maximum Target Torque =
offset * 24 + 240
100 ft-lb wrench:
Maximum Target Torque =
offset * 8 + 100
250 ft-lb wrench:
Maximum Target Torque =
offset * 12 + 250
Offset Max Target Offset Max Target Offset Max Target
-1" 216 in-lb -1" 92 ft-lb -1" 238 ft-lb
-2" 192 in-lb -2" 84 ft-lb -2" 226 ft-lb
-3" 168 in-lb -3" 76 ft-lb -3" 214 ft-lb
-4" 144 in-lb -4" 68 ft-lb -4" 202 ft-lb
Note: When using a negative offset, entering a target torque greater than maximum values above
may cause an overtorque error before reaching fastener target torque and possibly damage
wrench.
Viewing Stored Torque and Angle Data
Torque data is stored in memory after each torque cycle if applied torque has reached target value.
Torque and angle data is stored in memory after each angle cycle if applied angle has reached target
value. Memory Indicator is displayed when data is stored in non-volatile memory.
1.
To view stored torque and angle data, from target torque or angle screen, press and hold ENTER


button for 3 seconds.
2. Highlight SHOW DATA menu selection by pressing UP


/DOWN


buttons then press
ENTER


button to display Show Data screen.
00
M
100.0
FT-LB
00
OFFSET IN USE
M
100.0
FT-LB
ENTER button (after length change)
EXIT
SET HEAD LENGTH
SHOW DATA
M
CLEAR DATA
SET HEAD LENGTH
M
0.000
IN
M
ENTER
button
held
Target Screen
ENTER
button
UP/DOWN buttons
UNITS
button
SET HEAD LENGTH
M
0.0
MM
M
UP/DOWN buttons