Snap-On 642672, Инструкция по эксплуатации

Страница: 15 / 29

OPERATING THE PRESSURE WASHER
ALWAYS wear approved safety glasses when operating Pressure
Washers. Spray can splash back or propel objects, including
incorrectly attached accessories.
The high pressure stream of water that this equipment produces can cut
through skin and its underlying tissues, leading to possible amputation.
Spray gun traps high water pressure, even when the motor
is stopped and water is disconnected, which can cause injury.
Kickback from spray gun can cause you to fall.
1. For your protection, wear the protective safety glasses (provided).
2. Place the Pressure Washer near the working surface.
Make sure that the water source is turned on and all connections
to the Pressure Washer and Spray Gun are secure and without any water leakage.
3. Carefully remove the gun from its holder.
4. Hold the gun securely with both hands. Point the gun in a
safe direction. Make sure that the gun safety (the button
above the trigger) is unlocked and squeeze the trigger to
allow any air that is trapped inside the unit and hoses to
escape. Continue to squeeze the trigger until a steady
stream of water comes from the nozzle. Release spray gun trigger.
5. Turn on the ON/Off switch on the front of the Pressure
Washer. NOTE: Motor does not start until trigger is pulled.
6. Point the gun in a safe direction and squeeze the trigger
to start motor and water flow.
Make sure wand is
SECURELY tightened to Gun. If the wand is not
securely locked into place, it could be ejected
under high pressure when operating the gun,
possibly causing injury or damage.
14