SMSC USB3503, Руководство пользователя

Страница: 7 / 12

USB3503 Evaluation Board Manual
SMSC USB3503 EVB 7 Revision 1.0 (08-22-11)
USER MANUAL
4 Software
The USB3503 EVB comes with a CD that contains evaluation software that can be used with the Total
Phase Aardvark USB-I
2
C adaptor (not included with the Evaluation Kit). To install the software, run
Setup.exe , found on the CD. This will install the USB3503 Evaluation Software, the LabVIEW Run-
time engine (to run the executable), and the Total Phase drivers to communicate with the Aardvark.
Once the software has been installed, locate and run the
USB3503 Evaluation.exe program on the
computer. Connect the Aardvark to the USB3503 EVB with the red wire facing the power port, as in
Figure 4.1 .
The software allows the user to control the digital input pins RESET_N and CONNECT. It also can
monitor the INT_N pin for interrupts. There is a section to communicate with the I
2
C serial port, as well
as some quick configuration and customization options.
Figure 4.1 Aardvark Connection
Figure 4.2 USB3503 Evaluation Screen