4
LED Lights Explanation and Troubleshooting
Each flash indicates 3dB of gain reduction also known as gain attenuation.
For example: three flashes equals 9dB of attenuation.
Green LED
indicates loop oscillation status. When flashing it means reduction of
gain. To improve you need to spread the distance between the inside and outside
antennas. If you spread them far enough away, the Green LED
will become SOLID ON.
Orange LED
There are 5 Orange LED lights: 700 Mhz Lower, 700 Mhz Upper,
850 Mhz, 1700/2100 Mhz,1900 Mhz ext.
LED ON state indicates that the RX (Receive Signal) function of the band is
functioning normally.
LED OFF
(Green or Orange): indicates that the band is shut down.
When flashing it means reduction of gain also known as attenuation of gain.
You cannot prevent this condition. As you drive away from the nearby cell tower
and get far enough away the flashing Orange will automatically stop flashing
which indicates that the booster is no longer attenuated. As you approach
another nearby cell tower the Orange may begin flashing again and will stop
flashing as you get farther away. This is the normal operating process.
Typical Installation Stealth M2M X6 (Fig. 3 )
