If you need help pls contact [email protected] and we will help
you determine your cell tower location and get you setup.
Optional Dual Inside Antenna Installation (Fig. 2)
(Additional parts required which are not included in Booster kit
1) Choose a splitter model for your needs. For 2 interior antennas use a 2 way
splitter and for 3 interior antennas use a 3 way splitter etc…
2) Mount the interior antennas in the areas which need cellular coverage
3) Evenly distribute the antennas throughout the floors and areas to cover
4) Turn on Booster unit and check signal strength improvement as needed
Band 12, 17 700MHz Lower
Band
Frequency
Band 13
700MHz Upper
Band 5
850MHz
Band 4
1700/2100MHz
Band 2, 25
1900MHz ext
RX High Power Attenuation
Oscillation Attenuation
Orange LED
Green LED
Hp Att
Osc Att
Understanding the LED Indicators
The LED lights on the booster face plate indicate the operating gain state
of the booster.
The Green and Orange lights indicate the gain status in each operating band
When Both Green and Orange LED's are “SOLID ON” it means that the booster
is operating normally with full gain (No Automatic Gain Reduction)
When one or both of the LEDS are flashing (Per the chart on back page)
it indicates that the gain has been automatically reduced due to either:
A) High RX outside signal level (close to cell tower)
B) Loop Oscillation, caused when the inside antenna is located too close to the
outside antenna.
[email protected] Tel: 1 877 726 3444
3