Smittybilt X20 10,000LB, Руководство по установке

Страница: 18 / 24

Step 1: Remove the control box mount brackets (if attached) then remove the four small phillips
screws in order to remove the box cover. (Fig A2) remove cover carefully.
Step 2:
Step 3:
With care pull receiver off of base. (Fig B2)
It is recommended to make some notes and or take a picture to ensure proper
placement of wires.
Step 4: Disconnect wires that come from your current receiver.
Step 5: Connect the new receiver wires to the same mounting points as the previous.
(Fig C2,D2)
Step 6: Re-install the control box cover with previously removed screws.
(Fig A2) (Fig B2)
(Fig C2) (Fig D2)
A. White wire goes to the left on the ISM above the other White wire
B. Yellow wire goes to the right on the ISM above the Blue wire
C. Red wire goes to the front of the ISM where the long battery Red wire is connected
D. Black wire goes in the center of the ISM above the other Black wire.
E. The Green wire is the antenna (leave loose)
Wireless Receiver Replacement