For Technical Support/Warranty Information please call 310-762-9944
Smittybilt, 400 West Artesia Blvd, Compton, CA 90220
Installation Instructions
(Part # Q89)
Dual Cylinder Air Compressor
WWW.SMITTYBILT.COM
Step Eight:
Allow the compressor to cool and place neatly in the carry bag with the clips securely fastened
to the loops on the carry bag. To prevent damage to the unit during storage repack in the
original Styrofoam and color box. Store the unit in a dry location.
Step Nine:
Remember to replace the valve cover on the stem.
Operating Hints:
Turn the compressor on before connecting to the tire in order to reduce stress on the motor.
We recommend an on\/off cycle time of 20 minutes rest/off for every 40 minutes of run time.
To prevent damage to the air hose fitting, remove the inflator from the tire before disconnecting the hose from
the compressor.
Troubleshooting:
If the unit stops during operation:
1. Check the battery condition. Low voltage can blow the fuse or trigger the protection feature.
2. Check the circuit breaker reset if necessary.
3. The unit is equipped with an automatic protection device. In the event the unit reaches an
unsafe operating temperature, a protection circuit will cut power to prevent damage to the
unit. If the protection circuit activates, immediately disconnect the unit from the power
source and allow it to cool.
Resetting Circuit Breaker:
The circuit breaker is located next to the on/off switch. During normal operation it remains
in the down position almost even with the base. In the event of and overload it will pop-up.
If this happens, turn the power switch to off, disconnect the air hose and power cord. Push
the breaker down to reset and resume operation.
If air is leaking from inflator end:
1.
The inflator end has a dual function, to inflate and deflate your tire. Be sure to fully extend
the brass inflator to inflate your tire. Push back and turn the brass end to deflate.
2.
Inspect inside the ez twist inflator for damage to the O rings. If they are damaged contact
Smittybilt for a replacement hose.
