Smittybilt 97612, Инструкция по эксплуатации

Страница: 8 / 24

8
Winch Mounting
After turning on the winch or plugging in the
remote you must always select a direction in
order for the trigger to operate.
3. Recheck all cable rigging before proceeding.
4. Plug in the winch hand control. It is recommended
that the winching operation takes place from the
driver's position to ensure safe operation.
5. To commence winching operation, start vehicle
engine, select neutral in transmission, maintain engine
speed at idle.
6. Operate the remote control switch to the IN or OUT
position until the vehicle has been retrieved. Regularly
check the winch to ensure cable is winding onto the
drum evenly.
WINCH MOUNTING
The fitment of winches and/or a frontal
protection system may affect the
triggering of SRS airbags. Check that the
mounting system has been tested and approved
for winch fitment in the airbag-equipped vehicle.
Failure to comply may cause death or severe
personal injury.
The winch is to be mounted into a suitable steel
mounting frame using the 4-pont foot mounting system
either a horizontal or vertical plane. It is very important
that the winch be mounted on a flat surface so that the
three sections (motor, cable drum and gear housing) are
properly aligned.
Winch mounting frames and/or frontal protection systems
are suggested to suit most popular vehicles. Winch
frames are packaged with detailed fitting instructions.
The winch should be secured to the mounting with the
M10x 32mm bolts and spring washers provided. Winch
plate must be at least 6mm thick. Thicker winch plates
may require longer bolts (not included). Ensure winch
mounting bolts protrude past the top surface of the
square nut.
The roller fairlead is to be mounted so as to guide the
rope onto the drum evenly.
NOTE: The gear box and motor assembly are
not clockable. Attempting to do so can cause
damage to the winch and voids warranty.
DO NOT FORCE CLUTCH HANDLE.
Rotate drum to align gear in order to free spool if
needed.
ROPE IS NOT COVERED UNDER THE
MANUFACTURER WARRANTY. THIS IS A
NORMAL WEAR AND TEAR ITEM.
Inspect rope before first use during the
mandatory pre-stretching. Any defects must be
noted before initial use.
Improper use, inadequate fairlead to bumper
clearances, abuse, neglect, chafing damage are
not covered by any warranty.