WWW.SMITTYBILT.COM
For Technical Support/Warranty Information please call 310-762-9944
Smittybilt, 400 West Artesia Blvd, Compton, CA 90220
Installation Instructions
Winch Quick Connect Kit
Part # 35220 (8’)
Part # 35210 (24’)
Step 5:
Re-install the plastic control box cover you previously removed. Installation of the 3’ connect is
now complete. (Fig E) You may bolt on your winch to your desired accessory.
Note:
You can gain access to one piece winches that have the control box integrated into the design
of it by typically by removing the upper large bolt and loosening the lower ones. This will enable
you to either remove or flip forward the cover to gain access to the control box.(Fig F)
WARNING:
Always check with your winches owners manual before attempting to remove any
bolts or remove anything from your winch. Follow your winches wiring diagram when installing
the 3’ connect.
(Fig D)
(Fig E)
(Fig F)
Battery Quick Connector (8ft, 24ft)
Step 1:
Determine the best location to install the disconnect plug. Make sure you will be able to gain
access to it based on the accessory you will be using it with.
Step 2:
Run the cable along the frame of the vehicle towards the engine compartment. Take notice to
which side your battery is located when routing wires.
Step 3:
Run the cable into and up through the engine compartment towards the battery.
NOTE:
Make sure no accessory is connected to the plug before attaching wires to the battery.
Failure to follow and comply to these instructions entirely can lead to serious
injury or damage.
