Unit Inspection
Before starting the installation, carefully remove the fan convector from its box. Inspect for any damage that may
have been caused in handling.
Locating the fan convector
Profile series fan convectors are designed to give high BTUH capacities from a small cabinet. They should be
installed as near to the area of greatest heat loss as possible. The removable skirt enables mounting flush to the
floor or above the baseboard. Ensure adequate space to remove the cover for service and installation. Access to
piping and electrical connections are through the back OR bottom of the unit.
Preparing the site
Take off the outer cover by first removing the screws located on each side, then gently lifting the casing upward
and away from the chassis. Determine the exact location of the unit and place the chassis against the wall. Mark
the locations of the piping and electrical cutouts.
Note: The piping and electrical connections may be made through the back OR bottom of the unit.
Set the chassis aside and prepare piping and electrical accordingly. To remove the bottom skirt, turn the chassis
over and take out screws located in the underside.
Installing the fan convector
Profile fan convectors are equipped with the E-Z hanger mounting strip to make installation simpler. Make a
straight level line on the wall per the diagram below. Center the E-Z hanger strip on the line and secure with the
screws provided.
Note: Make sure that the E-Z hanger strip is level. Mount the chassis by engaging the slots in the rear onto the E-
Z hanger strip. Screw the bottom of the unit into the wall through the holes provided.
Model
A
B
C
D
PSU10 12.03 6.25 5.50 5.00
PSU15 12.03 21.75 3.87 3.37
PSU23 12.03 21.75 9.50 8.87
PSU30 19.19 21.50 4.75 4.25
PSU40 19.19 21.75 9.0
9.0
Make sure the fan convector is level and secure to the wall.
