Smithco Fairway Ultra 10 12-500-B, Запчасти и обслуживание операторов

Страница: 37 / 46

35
Accessories
INSTALLATION INSTRUCTIONS
Safety: Before working on machine stop engine, set park brake, remove key from ignition and block
wheels. Disconnect negative (-) battery terminal.
1. Mount the switch box to the panel to the right of the operator's seat. Remove the drill screw on the right
hand rear side and mount the Switch Box (Ref. G) using this screw. The switch box must be mounted
facing towards the operator's seat.
WIRING
Use dielectric grease on all electrical connections. Connect power cable (15-509) to the switch box. Turn the
switch off. Route the power wire to the fuse block (on the inside of the engine cover) out of the way of any
heat or moving parts. Use nylon ties as needed. Cut the power wire with enough length to connect the fuse
block. Put the slide on terminal with heat shrink onto the wire ends and connect to fuse block. Red to posi-
tive(+), black to negative(-). Insert 15 amp fuse into slot which has red wire attached to it.
MOUNTING THE FOAMER UNIT
1. Position the Mount Plate (Ref. 5) as illustrated and mount to the Tank Carrier using two
1
/
4
-20 x
3
/
4
Flange Bolts and
1
/
4
-20 Flange Lock Nuts. Leave loose.
2. Connect Brace (Ref. 2) to the Mount Plate using one
5
/
16
- 18 x
3
/
4
Flange Bolt and
5
/
16
- 18 Flange Lock
Nut. Tighten. Bolt Brace (Ref. 2) to the tapped hole in the mainframe using one
5
/
16
- 18 x
3
/
4
Flange
Bolt. Tighten.
3. Tighten hardware connecting Mount Plate (Ref. 5) to the Tank Carrier.
4. Place Foamer unit (Refs. A-G) on the Mount Plate (Ref. 5) and bolt in place with four
5
/
16
- 18 x
3
/
4
Flange Bolts and
5
/
16
- 18 Flange Lock nuts (Ref. 1). Foamer must be placed with the Cap Assembly
(Ref. B) facing to the
rear
of the machine.
5. Tighten hardware.
CONNECTING THE CAP ASSEMBLY
Connect the blue tube to the tank cap connector which is also connected to the large blue tube which hangs
below the cap. This is the soap outlet tube. Connect the clear tube to the other connector on the tank cap.
This is the air input tube. Tighten connectors hand tight, assembly tank cap onto tank.
HOSES
Being careful not to cut the tubing, cut the oversleeve back approximately 2" (5 cm) to expose blue and clear
tubing. Remove blue wing nut from top connector of foam nozzle and slide it on the blue tube with the threads
facing toward end of tube. Slide blue tube all the way over the top of the small tube on foam nozzle. Slide
wing nut back to the threads and hand tighten. Follow the same steps for the clear tube and tube nut.
Route the tubing along underside of main frame using tie downs as necessary.
Install opposite ends of air-liquid tubes to compressor, again cutting back the oversleeve approximately 2" (5
cm) and inserting blue and clear tubes for the left boom section into the tubing connectors on the right side of
compressor as far as possible. Follow the same steps for the right boom tubing. Notice the right boom is in-
serted into left side of compressor. To release tubing from compressor, hold black ring around tubing, and pull
tube out.