Smithco 45-204, Запчасти и обслуживание

Страница: 137 / 161

C-79
Rear Attachment
45-176 72" DRAG MAT + FINISHER BRUSH PARTS LIST
REF# PART# DESCRIPTION QUANTITY
1 13-688 Brush Channel 1
HB-14-20-075 Hex Bolt, 1 /
4
- 20 x 3 /
4
2
HNFL-14-20 Flange Lock Nut, 1 /
4
- 20 2
2 43-168 Brush Mount Arm 2
HB-14-20-075 Hex Bolt, 1 /
4
- 20 x 3 /
4
8
HNFL-14-20 Flange Lock Nut, 1 /
4
- 20 8
3 13-683 Brush Track 1
4 13-682 Brush, 77 x 11 1
5 43-164 Adjustment Handle 1
6 43-166 Mat Clamp 4
HB-38-16-125 Hex Bolt, 3 /
8
- 16 x 1 1 /
4
8
HNFL-38-16 Flange Lock Nut, 3 /
8
- 16 x 1 1 /
4
8
7 43-165 Frame 1
8 45-167 Steel Mat, 72 x 29 1
9 43-162 Draw Bar 1
HHP-18 Bridge Pin, 1 /
8
1
10 43-163 Lock Handle 1
11 HCP-12-300 Clevis Pin, 1 /
2
x 3 1
HHP-18 Bridge Pin, 1 /
8
1
DRAG MAT ASSEMBLY INSTRUCTIONS
Some components of your Drag Mat + Finisher Brush have been assembled at the factory for your conve-
nience.
1. Start by mounting the Drawbar (Ref 9) to the Frame (Ref 7) using the Clevis Pin and Bridge Pin (Ref 11).
Position the Drawbar, using either set of holes, as illustrated.
2. Next, mount the Brush assembly (Ref 1, 3 & 4) to the Brush Mount Arms (Ref 2), as illustrated, using the
(6) 1 /
4
- 20 x 3 /
4
Hex Bolts and 1 /
4
- 20 Flange Lock Nuts. Secure fasteners tight.
3. The holes on each of the Brush Mount Arms will line up. Mount to the pin on the Drawbar (Ref 9) and
secure using the remaining Bridge Pin.
4. Thread the Lock Handle (Ref 10) on to the Adjustment Handle (Ref 5). Thread the Adjustment Handle into
the nut on top of the Drawbar (Ref 9), continuing until the threaded rod is through the Drawbar tube. Turn
the Lock Handle clockwise (

) to lock the Adjustment handle in place.
Adjusting the Steel Mat Finisher .
Adjusting the leading edge (front) will affect the performance of the Finisher . Various field compositions
and conditions can benefit from fine tuning of the Finisher's leading edge angle.
1. Release the Lock Handle (Ref 10) by holding the Adjustment Handle (Ref 5) and turning the Lock Handle
counter-clockwise (

).
2. To raise the leading edge (front) of the Finisher , turn the Adjustment Handle clockwise (

). When you
obtain your desired position, turn the Lock Handle clockwise (

) to lock the Adjustment handle in place.
3. To lower the leading edge (front) of the Finisher , turn the Adjustment Handle counter-clockwise (

). When
you obtain your desired position, turn the Lock Handle clockwise (

) to lock the Adjustment handle in
place.