Smithco 12-750-A, Руководство по эксплуатации и ремонту

Страница: 6 / 36

4
Introduction
SETUP
Battery not included.
1. Install an Automotive type 24F-12 Volt battery into the Power Box and secure with the battery hold-down.
2. Fill the power unit with approximately 1.50 Gal (5.68 liter) MileMaster 303 Tractor HYD Fluid or equivalent.
3. Connect hitch to tow vehicle. Adjust hitch as necessary to level roller frame. Best performance is achieved
with roller frame level or hitch slightly up.
4. Install charge cable to tow vehicle battery.
A. Route cable to battery on the tow vehicle. Avoid exhaust, heat and moving parts.
B. Connect (-)black cable to battery ground (-).
C. Connect (+) red/black short cable to battery po).
D. Connect (+) red/black short cable to main cable through fuse cartridge.
E. Connect plugs at hitch, leaving enough cable slack for turning.
5. Fill water tank with water. Tank holds 150 gallons (567,8 l). Tank
must be full for proper operation.
6. Connect control cord. Turn main switch off and hand switch to
center position to avoid unintentional operation.