Setup
8
3A6354A
Setup
Handle Bar Adjustment
The handlebars are equipped with a high-density
vibration suppression material to reduce operator fatigue
when operating equipment. To adjust the handlebars to
a new position for different height operators please follow
these steps:
1. Using a 9/16” (14mm) wrench or socket, loosen the
bolts on both sides of the handlebars until the
handlebar moves freely.
2. Stand behind the machine and lightly tap the
handlebar to the desired position.
3. Re-tighten the bolts to 21.7 to 25 ft-lb (29-34 N•m) to
lock the handlebars into position.
NOTE: Never operate equipment with loose handlebars.
The bolts must be fastened tightly assuring the handle is
locked into position.
Engine Kill Button
In the event of a malfunction or an accident (such as the
machine operator falling or losing footing), the LNX8 is
equipped with a corded Engine Kill Button. Attach the
end of the cord to the operator’s belt or wrist, and snap
the clip into place on the button by raising the top of the
Engine Kill Button and inserting the clip into the gap. If
the operator becomes distanced too far from the
machine, the cord will detach from the button and the
machine will stop running. The engine can also be
stopped by pressing down on the Engine Kill Button.
Cutter Head
Installation/Replacement
Normal use will require periodic cutter head inspection
and may necessitate cutter replacement. Time of
replacement will vary according to usage and load
factors.
1.
Non-DCS Models:
Raise the Cutter Head Engage
Lever to the up position so the cutter head is off the
ground.
DCS Models:
Press the Home Button on the DCS
Control so the cutter head is off the ground.
2. Remove Clevis Pin.
To avoid injury from unexpected start up, disconnect
spark plug wire and black battery cable before you
service your unit.
