STEP 1 - TO “PAIR” REMOTE TO THE A BLIND
1. Press the Programming Button on the motor with a paperclip
for one jog.
2. Press P2 on the remote. (
Blind will jog.
)
3. Press P2 on the remote. (
Blind will jog.
)
4. Press UP or DOWN arrow. (
Blind will jog.
)
The remote will now work with the blind.
STEP 2 - LIMIT SETTING MODE
1. Press P2 on the remote. (
Blind will jog
.)
2. Press the UP arrow on the remote. (
Blind will jog
.)
3. Press P2 on the remote. (
Blind will jog
.)
STEP 3 - SETTING LIMITS
1. Move blind to the desired Opened/Closed positon, STOP the
blind and continue to hold STOP until the blind jogs. The Limit
is now set. (
Please make sure not to close the slats too tight
.)
2. Move blind to the desired Opened/Closed position, STOP the
blind and continue to hold STOP until the blind jogs. The limit
is now set. (
Please make sure not to close the slats too tight
.)
3. If limits need to be adjusted after setting, go back to “LIMIT
SETTING MODE” and follow “SETTING-LIMITS”.
smithandnoble.com
800.248.8888
CAUTION
: When setting limits on tilt products, be advised that setting the closure of the slats too tight can result
in the breaking of the strings/ladders. Please use caution when adjusting the limits.
STEP 4 - SETTING 3
RD
LIMIT, “FAVORITES POSITION”
1. Move blind to the desired FAVORITES Position.
2. Press P2 on the remote. (
Blind will jog.
)
3. Press STOP on the remote. (
Blind will jog.
)
4. Press STOP on the remote. (
Blind will jog.
)
To activate 3
rd
limit, press the STOP button for approximately 2 seconds. Blind will move to the set position.
The FAVORITES stop is set.
These directions are for programming a motor from a factory default
state. If the blind has been programmed and other adjustments
need to be made, additional directions will be at the end of the
document. Please read entire document before programming.
Motivia® Motorization
Programming Guide For Durawood & Wood Blinds
PROGRAMMING BUTTON LOCATION
Programming button is located
on the
blind motor,
inside the headrail.
PROGRAMMING BUTTON
REMOTE INFORMATION
REMOVE BACK
COVER
P2 BUTTON
BATTERY
P2
BATTERY
P2
MOTOR
