COSMOS 302X series servo drives / inverters
Installation, use and maintenance manual - EN
Ver. 1.01
15
4.6 Accessories
The COSMOS 302X series servo-drives / inverters are supplied with the complete set of detachable connectors
for power and I / O connections (where provided). The same connectors can be ordered separately as well as
other accessories not included in the drive. Below is the list of order codes:
4.7 Electromagnetic compatibility (EMC)
The servo-drives/inverters comply with IEC 61800-3 2004-12 requirements; they must be installed in the
second environment, category C3, on the following conditions:
• The connection between the drive and the motor is made by means of an adequately sized shielded cable.
• The shielded cable must be connected to earth on both sides, with low RF impedance connection
• The motor type and size are suitable for the servo-drive
• The start-up is performed by technical engineers, according to the instructions of this manual.
Order code
Article
KF101068
24VDC and I / O power connector (8x1)
These servo-drives are not designed for domestic environment (
first-environment
, accord-
ing to IEC 61800-3 Standards). In this case, it will be necessary to install an additional mains
filter.
The integrated filter ensures compliance with the IEC 61800-3, only if a single servo-drive
is operating. The simultaneous operation of more than one servo-drive might increase the
noise level and might exceed the emission levels fixed by the standards. In this case, an
additional filter may be necessary.
