Smeg WDI14C7-2, Инструкция по эксплуатации

Страница: 4 / 78

EN
3
vents, degreasers, stain remover additives…) for their correct use and dos-
age. Failure to comply with the recommendations provided may damage the
appliance.

WARNING : the higher the spin speed, the higher will be the noise and the
lower the remaining moisture content. The lower the amount of residual mois-
ture at the end of the wash, the lower the energy consumption will be during
drying."
Safety instructions

This appliance is intended for domestic use and similar applications such as
staff kitchen area in shops, offices and other working environments, farm
houses, and for the use by clients in hotels, motels, bed and breakfast type
environments, and other residential facilities and is compliant with Directives
2014/35/EU and 2014/30/EU currently in force.

Read all the instructions in this manual carefully before installation and use.

Check that the drum assembly has been released before use (see instruc-
tions). Failure to release the drum assembly may cause damage to the
washer-dryer and the surrounding furniture or appliances during the spin cy-
cle.

This Instruction Manual is an integral part of the appliance: it must always be
kept intact with the appliance. Installation must be carried out by qualified
staff in compliance with the relevant regulations. The appliance is built to pro-
vide the following functions: washing and drying of clothes or fabrics stated
to be suitable for machine washing by the producer on the relevant label. All
other uses are to be considered improper.
The manufacturer declines all
liability for uses other than those stated above.

The nameplate with the technical data, serial number and mark is in a visible
position in the part in view after the door has been opened. The nameplate
must never be removed.

The electrical and plumbing works required to install the appliance
must only be carried out by skilled staff.

The appliance must be connected to earth in compliance with electrical sys-
tem safety regulations. The manufacturer declines all liability for direct
or indirect injury or damage deriving from a non-existent or defective
earth connection.

In the event that the appliance is not connected by means of a plug, an om-
nipolar circuit-breaker device with contact gap of at least 3 mm must be pro-
vided.

The plug to be connected to the power supply lead and the relative socket
must be of the same type and comply with the relevant regulations. Check
that the mains voltage and frequency are the same as the values marked on
the nameplate. The use of adapters or junctions is not recommended. Never
disconnect the plug by pulling on the power supply lead.

The appliance is only disconnected from the electricity supply if the
plug has been removed from the socket or the electrical system master
switch has been turned off. The power plug must be accessible after
the appliance has been installed.