Smeg WDF147XS, Инструкция по эксплуатации

Страница: 20 / 25

EN
19
5.3 DISPLAY MESSAGES IN RESPONSE TO INAPPROPRIATE LOADS
LO
Load too low – the programme stops after about 35 minutes to avoid damaging the laundry
HI
Load too high – the programme goes ahead with the drying cycle, with the following maximum times:
Normal drying programme
(duration in h:mm)
Delicate drying programme
(duration in h:mm)
2:40 2:00
5.4 DRY ONLY PROGRAMME
1. Turn the appliance off by turning the washing/drying programmes selector knob to OFF.
2. Turn the knob to the drying programme required: Intensive drying: for normal drying (90°C), or Gentle drying:
for delicate fabrics (60°C). To find out which symbol identifies each drying programme, refer to the pro-
grammes table supplied with the appliance.
3. Press the Dry button repeatedly to set the drying mode required (see previous point).
4. Press the "Start-Pause” button to start the drying programme. The display shows the time remaining and the
drying symbol LED lights up.
Attention
•
Since no washing programme has been set previously, there are no constraints on selection of the drying
programme (normal or gentle). Remember that normal drying is recommended for cotton and coloureds, and
gentle drying for synthetic and delicate items.
•
For good drying results, the load of laundry must not exceed 4kg of cotton or 2kg of synthetic fabrics.
5.4 INTERRUPTING OR CHANGING THE DRYING PROGRAMME
1. The drying programme can be interrupted by the same procedures as the washing programme.
2. To end the programme and remove the laundry, it is best first to cool the load. Use the selector button to set
a drying time of 20 minutes. Restart the appliance as described above and the laundry will be ready for re-
moval.
5.5 CLEAN PROGRAMME
To keep the appliance operating at peak efficiency over time, it has a CLEAN programme for regular cleaning of
the drying circuit to remove any fluff deposits.
1. After a given number of drying cycles, the CLEAN symbol lights up on the display to warn that this pro-
gramme needs to be run. The warning light remains on until the CLEAN programme is carried out. The light
goes out at the end of the programme.
2. To perform the CLEAN programme, proceed as follows:
a. Make sure that the drum is completely empty and close the door.
b. Turn the knob to the CLEAN programme (see programmes table for the exact position on the knob)
c.
Press the START/PAUSE button
The CLEAN programme can also be carried out even if the light on the display is not on.
CLEAN
programme
symbol