18
USER program duration customisation (optional, only if installed)
USER. is the only program which can be customised.
Scroll through the setup parameters to display USER.P1,
P2….. followed by two dashes (e.g. P2--). Keep pressing the P
button until USER appears followed by the duration
(e.g. USER. 03.10).
Steam extraction time setting (optional if installed)
Steam extraction system operating time display and setting.
Service setting (for After-Sales Service only)
See information on Smegtech
7.3
Starting the peristaltic pumps – rapid filling of detergent and rinse aid delivery
circuit.
Perform after the parameter modification procedure explained in the previous point
With the dishwasher powered up and the tank full, press the
on/off
button for a few seconds; when ------ appears on
the display, release the button and press it again quickly
within 0.5 seconds.
The peristaltic pumps continue to operate until the same
button is pressed again. The rinse aid and detergent symbol
lights flash alternately as long as the pumps are on; bear in
mind that the rinse aid peristaltic pump fills the circuit in
about 7 minutes, while for the detergent it only takes 2
minutes. So draw only rinse aid from the jerry cans (1 for the
rinse aid and the other for the detergent) for the first 5
minutes and then also take in detergent for the last 2.
On some models, the message
“door”
(PCB self-diagnostics on dishwasher closure) may
appear during the setup procedure. To reset the message, open the dishwasher door and
close it again. If the message persists, contact the after-sales service.
