6
3
INSTALLATION AND POSITIONING
INSTALLATION and POSITIONING
Bring the dishwasher to the installation site, remove the packaging and check the appliance and components for damage; any
damage found must be reported to the transporter in writing. The packaging components (plastic bags, expanded polystyrene,
nails, etc.) must not be left within reach of children and pets since they are potentially dangerous. All packaging materials used
are environment-friendly. They can be kept without constituting any hazard, or may be disposed of at a specialist waste disposal
centre. The plastic components suitable for recycling are marked as follows: PE polyethylene: external packaging film, bag
containing the instructions, protective bags. PP polypropylene: straps. PS expanded polystyrene: corner guards, top of
packaging. Wooden and cardboard components can be disposed of in accordance with the relevant regulations.
When the product is decommissioned it must not be dumped in the environment; it must be disposed of in accordance with the
relevant regulations. All metal parts are in stainless steel and can be removed. The plastic parts are marked with the symbol
identifying the material used.
Positioning
Warning:
the indoor system and premises in which equipment for institutions is installed must comply with
the relevant regulations.
The manufacturer declines all liability for direct or indirect injury or damage deriving from failure to comply with these
regulations. Before installation, check that there are no objects or materials near the machine which may be damaged by steam
or splashes of washing solution, or that such items are suitably protected. Place the dishwasher in the chosen point and remove
the protective film. Level the dishwasher (with the aid of a spirit level) on its adjustable feet to ensure that it is stable; all other
mounting solutions must be approved by the manufacturer.
4
INSTRUCTIONS FOR TECHNICAL STAFF
4.1
Plumbing hookup
PLUMBING HOOKUP
The water pipelines and electricity supply cable lead out of the bottom right-hand corner of the appliance.
Connect the water intake hose to a connector with
¾” gas
threaded fitting, fitting the filter A provided (in
models with Acquastop, the filter and ring-nut form a single unit). The connection to the water mains must
only be made with new hoses; the use of old or worn hoses is not permitted.
The dynamic
water supply pressure
must be between
1 and 6 bar
(according models); if it is higher, installation of a pressure
reducer is necessary. If the pressure is
less than 2.5 bar
(models without rinse pump) it might be necessary to fit a special pump
on the appliance to ensure optimal performance.
Contact the After-Sales Service.
It is essential to fit a main stop tap on the
water intake deliver pipeline; the tap must be accessible after installation of the appliance, so do not install it behind the
dishwasher. The stated cycle duration applies to appliances supplied with
hot water >50°C<60°C.
If the dishwasher is supplied
with cold water, the cycle duration might increase depending on the intake water temperature.
Drainage:
The dishwasher
is
fitted with a drain pump
and can operate with drain connections on the floor or wall. Refer to the connection diagram for the
maximum permitted height of wall drains – (see TECHNICAL DATA)
Warning:
make sure that the intake and drain hoses are not bent, constricted or crushed after installation.
Содержание UD505DUK
Страница 1: ...PROFESSIONAL DISHWASHER ...
Страница 2: ......
