8
Rev 0.0
USER INSTRUCTIONS
EN
Only
run the soak program with half loads.
After using the above table to choose the most suitable washing cycle, pro-
gram the appliance.
Before starting a washing program, make sure that:
The water supply tap is
open.
There is regenerating
salt in the water softener
tank
(to add
salt, see the instructions in the general manual).
The correct amount of detergent
has been added to the
dis-
penser
(to add detergent, see the instructions in the general
manual).
The spray arms are able to rotate
freely
and without obstruction.
The racks have been
correctly loaded
(see the instructions in the
general manual).
The dishwasher door
is securely closed.
2.2.1 Switching
on
Press the on/off button (ref. 1 fi g. 2-02) to start the dishwasher. Then wait for
one of the
program indicator lights
to turn on (ref. 2 fi g. 2-02).
2.2.2
Selecting and starting the program
Press the
program selection button
(ref. 3 fi g. 2-02) several times until
the indicator light corresponding to the required program turns on (ref. 2 fi g.
2-02);
if necessary, select, using the relative buttons, the complementary functions
you are interest in (e.g. “Programming delay”);
close the door; the program will start after about
2 seconds
and the relative
indicator light
will fl ash throughout the cycle (program running signal).
If the door of the dishwasher has not been closed or has been incor-
rectly closed, the washing cycle will not begin.
2.2.3 End
of
program
The end of the program is indicated by a brief acoustic signal and the (marked
by “end”) “auto delicate” and “extreme wash” program indicator lamps fl ash.
•
•
•
•
•
•
•
•
•
Содержание STA4645
Страница 3: ...2 Rev 0 0 EN...
Страница 19: ...2 Rev 0 0 EN...
Страница 49: ...32 Rev 0 0 USER INSTRUCTIONS EN A B A B Fig 5 02 Fig 5 03 Fig 5 04...
Страница 56: ...2 Rev 0 0 EN...
