Smeg SC45MK, Инструкция по эксплуатации

Страница: 14 / 31

GB-IE
Instructions for the User
15

Press PT1 to activate the parameter modification mode. The
symbol starts to blink. Turn PT1 to the right or left to change the
remaining cooking duration.

Press PT1 to validate and the next parameter light starts to blink.
Proceed as described in the active function chapter to modify the
remaining parameters.

Press PT2 to continue the cooking process.
7.5.3 Cancelling a cooking cycle
If you wish to cancel the cooking process, press PT2 for 3 seconds.
You will then hear a beep and the oven returns to the OFF setting.
7.5.4 End of a cooking cycle
At the end of the process you will hear three beeps and the display will
show the word “End”.
The beeps are repeated every 30 seconds until the door is opened or PT2
is pressed. The oven returns to the OFF setting.
7.6 Secondary menu
This appliance also has a concealed "secondary menu" allowing the user
to:
1. Activate or deactivate the Show Room function (which disables all the
heating elements so that only the control panel works);
2. Activate or deactivate the function which limits the maximum power
absorption to 2000 W;
3. Activate or deactivate the child safety device ( );
7.6.1 Show Room Function
With the o
ven in OFF status (see point “7.2 Operating settings”) keep PT1
pressed until the message OFF SHO appears on DSP1. This means that
the SHOW ROOM function (which disables all the heating elements so
that only the control panel works) is not active.
Turn PT1 to the right or left to activate (ON SHO) or deactivate (OFF SHO)
this function. To use the oven normally, set OFF SHO.
After setting the parameter required, press PT2 to return the oven to the
initial standby status.
7.6.2 Power selection function
This function allows the oven operation if there are limitations in the mains
power (e.g. 3 kW for Italian market). The cooking results will not be
affected but the cooking duration will be increased on some functions that
activated more than one heating element.
With
the oven in OFF status (see point “7.2 Operating settings”) keep PT1
pressed until the message OFF SHO appears on DSP1. Now press PT1
once again and the message “OFF 2000” will appear on DPS1.
Turn PT1 to the right or left to activate (ON 2000) or deactivate (OFF
2000) this function, which limits the oven's maximum power absorption, in
any function, to 2000 W.
After setting the parameter required, press PT2 to return the oven to the
initial standby status.