Smeg SAWD612, Инструкция по эксплуатации

Страница: 13 / 20

13
SM2831
OPTIONAL FUNCTIONS
GB
If one of the buttons listed below is selected, its symbol will appear on the display. While if
you realize that you have selected it by mistake or you have changed your mind, to cancel the
option, press it again.
PRE-WASH:
When this button is pressed, a short pre-wash with a maximum temperature of 40°C
lasting for about 10 minutes is provided.
This function can only be used on the “COTTON, SYNTHETICS and DAILY” programs.
N.B. If you use this option, the detergent must also be poured
into the appropriate compartment for the pre-wash.
INTENSIVE WASH:
When this button is pressed, the machine will carry out a wash at the set tempera-
ture but which lasts longer. This button works on the “COTTON and SYNTHETICS”
programs.
EXTRA RINSE:
The washing machine has been built so that water consumption is reduced to a mi-
nimum. For areas with very soft water or in the case possible residues of detergent
are noticed at the end of the cycle, pressing this button the machine will carry out
an additional rinse.
DRYING:
This button allows the drying time to be selected in minutes, both in automatic mode
(at the end of the wash cycle) and in manual mode (with hand washing).
The set time is that indicated by the lit led. If all the leds are off, the drying cycle will
not be effected.
(see table “RECOMMENDED DRYING QUANTITIES ANDTIMES”).
HOW TO USE THE WASHER-DRYER
USING THE DRIER:
The drying cycle can either be programmed to run automatically at the end of the “Cotton” and “Syn-
thetics” wash programs, or it can be started manually (in the case of hand washing, for example).
When using the manual drying function, the washing must always be spun fi rst at a minimum of 800
rpm. (see table “RECOMMENDED DRYING QUANTITIES AND TIMES”)
CONTINUOUS WASH/DRY PROGRAM
(COTTON AND SYNTHETICS):
Place the washing in the tub (see table “RECOMMENDED DRYING QUANTITIES AND TIMES”). Select
the required wash program using the programmer knob. Set the required functions using the various
buttons. Program the drying function by pressing the button with the symbol. Then press the Start
button. When the delay button (I) is pressed, the wash and dry program will start after the programmed
delay time.
N.B. Use of the optional functions is restricted by the type of program chosen; so, if the program
does not allow the function, it will not be possible to enable the button (see PROGRAM TABLE).