Smeg S863VG3, Инструкции по установке и использованию, Страница: 8 / 10

16
GAS TRANSFORMATIONS AND ADJUSTMENTS
Replacing the nozzles
If the equipment is adjusted for a type of gas that
is different from the one available, it is necessary
to replace the burner nozzles.
The choice of the nozzles to replace must be
made according to the table of the “technical cha-
racteristics”.
Act as follows:
- Remove the racks and burners.
- by means of a straight spanner L, unscrew the
nozzle U (fig.7) and substitute it with the corre-
sponding one.
- tighten the nozzle strongly.
Adjusting the burners
The lowest flame point must always be properly
adjusted and the flame must remain on even if
there is an abrupt shift from the maximum to the
minimum position.
If this is not so, it is necessary to adjust the lowest
flame point as follows:
- start the burner up
- turn the tap up to the minimum position (small
flame)
- remove the knob from the tap rod
- introduce a flat-tip screwdriver C in the hole F of
the tap (fig.8) and turn the by-pass screw up to a
proper adjustment of the lowest flame point.
As regards G30 gas burners, the by-pass screw
must be tightened completely.
7 8
Replacing the battery (fig. 9)
- Unscrew the cap T .
- Replace the battery B type alkaline AA 1,5 V
placing it in the spring M and making sure that
the “
-
” polarity faces upwards.
- Fit the battery into the battery holder and screw
down the cap T.
9