Instructions for the Installer
11
4. INSTALLING THE COOKTOP
1)
Remove the styrofoam protection and lift the cooktop in order to
extract it from the side protectors and the box.
2)
Fit the insulating gasket provided carefully around the outside edge of the hole made in the top as shown
below, pressing it down with your hands so that its entire surface fits snugly. Follow the dimensions
shown, depending on the model of cooktop to be installed, keeping in mind that on both models the long
front edge must be flush with the hole. Fasten the cooktop to the structure using the brackets
A
provided.
Carefully trim off the excess edge of the gasket
B
. The dimensions in the drawing below refer to the hole
on the inside edge
of the gasket.
NOTE:
Use all of the brackets supplied with the appliance to fasten it to the support structure.
3)
Always use pipe-joint compound made for use with NATURAL GAS
and L.P. GAS between pressure regulator
D
and (NPT) adaptor
C
and between pressure regulator
D
and pipe
E
. If a flexible metal
conductor is used, make sure that the tubing is not kinked.
Use only pipes (
E
) conforming to the standard regulations in force,
inserting the gasket
B
(supplied) between fitting
A
and adaptor
C
.
The adaptor
C
must be fitted on the gas connection
A
before fixing
the cooktop.
Always place a suitable sealing medium (such as Teflon tape)
between pressure regulator
D
and adaptor
C
and between pressure
regulator
D
and pipe
E
.
WARNING:
The tightening torque of adaptor
C
must not be greater than 1416.2 ozf-in.
