27
Instructions for the user
6. USING THE HOB
6.1
Gas hob
Before lighting the hob burners check that the flame diffuser rings are
correctly in place with their respective burner caps, making sure that the
holes
A
in the flame diffusers are aligned with the plugs and
thermocouples.
For the dual burner UR2, place the burner caps
G
and
F
on the burner
D
,
ensuring that they fit snugly. The burner must then be placed on and fitted
into the base
B
(taking care to use the pin
C
as reference). The pan stand
B
supplied is for use with woks.
The special pan stand
H
is for use with woks.
The burner controlled by each knob is shown next to
the knob. The appliance is equipped with an
electrical ignition device. Simply press the knob and
turn it anti-clockwise to the maximum flame symbol,
until the burner lights. If it does not light in the first 15
seconds, position the knob on 0 and wait at least 60
seconds before trying to light it again.
On valved models, once the burner is lit, keep the knob pressed for a few
seconds to give the thermocouple time to heat up. The burner may go out
when the knob is released: in this case, the thermocouple has not heated
up sufficiently. Wait a few moments and repeat the operation keeping the
knob pressed for a longer time. This is not necessary on burners that are
not equipped with thermocouple. Once the burner is lit, the flame can be
adjusted as needed. Always check that the control knobs are in the
(off)
position when you finish using the hob.
If the burners should go out accidentally, after about 20 seconds a safety
device will be tripped, cutting off the gas supply, even if the gas tap is
open. In this case, turn the knob to the OFF position and wait at least 60
seconds before trying to light the burner again.
