8
Rev 0.0
USER INSTRUCTIONS
EN
Only
run a soak program with half loads.
After using the above table to choose the most suitable washing cycle, pro-
gram the appliance.
Before starting a washing program, make sure that:
The water supply tap is
open.
There is regenerating salt
in the water softener
tank
(to add
salt, see the instructions in the general manual).
The correct amount of detergent
has been added to the
dis-
penser
(to add detergent, see the instructions in the general
manual).
The spray arms are able to rotate
freely
and without obstruc-
tion.
The racks have been
correctly loaded
(see the instructions in
the general manual).
The dishwasher door
is securely closed.
2.2.1 Switching
on
Press
on/off
(ref. 1 fi g. 2-02) to start the dishwasher; the indicator lights show
the “status” of the dishwasher.
2.2.2
Selecting and starting the program
Programming operations can only be performed with the
door clo-
sed.
With the door open, the
program
indicator lights (ref. 4 fi g. 2-
02) remain off.
Press the program
selection button
(ref. 3 fi g. 2-02) several times until the
indicator light corresponding to the required program turns on (ref. 4 fi g. 2-
02);
if necessary, press the relative buttons to select the complementary func-
tions you wish to use (e.g. “Programming delay”);
to start the dishwasher, press the
start/pause
button (ref. 2 fi g. 2-02) for a
few seconds until the indicator light of the selected program starts fl ashing
(confi rmation beep);
Program status is indicated by the indicator light fl ashing throughout the
cycle.
If the door of the dishwasher has not been closed or has been incor-
rectly closed, the washing cycle will not begin.
•
•
•
•
•
•
•
•
•
•
Содержание PLA68XU
Страница 3: ...2 Rev 0 0 EN...
Страница 20: ...2 Rev 0 0 EN...
Страница 54: ...36 Rev 0 0 USER INSTRUCTIONS EN Fig 5 02 Fig 5 03 Fig 5 04 A B A...
Страница 61: ...2 Rev 0 0 EN...
