Smeg PL7233TX, Инструкция по эксплуатации

Страница: 16 / 34

User instructions
14

Do not use table salt, as it contains insoluble substances which, over
time, may damage the water softening system.
 The salt container should be refilled when necessary before starting
the wash program. This way, the excess saline solution will be
immediately removed by the water; prolonged presence of salt water
inside the tank may lead to corrosion.
Be careful not to confuse the salt and detergent packages; adding
detergent to the salt container will damage the water softening system.
ADJUSTING THE SOFTENER
(available for all programs except the soak program)
The dishwasher is equipped with an electronic control system which
allows the softener setting to be varied to suit the hardness of the water.
To set the softener, proceed as follows.
 Keep the PROGRAM DELAY button pressed for a few seconds,
until the h.- symbol, followed by the set value, appears on the
DISPLAY.

Press the PROGRAM DELAY button again to select the most
suitable hardness value ( h.-0 , h.-1 , h.-2 ….. h.-6 ). Refer to the "Water
hardness table" to select the value.
 To exit the programming mode press any button or do not touch the
keypad for about
2 seconds .