Instructions for the Installer
12
3)
Carefully position the gasket provided all around the outer edge of the hole inthe work surface as shown
in picture 1, pressing it down lightly to ensure it adheres properly. The front and rear sides of the gasket
must skim the hole. Now place the hob on the insulating gasket and use the screws and fixing brackets
(fig. 3) to secure the hob to the supporting structure, adjusting it until perfectly horizontal. Carefully trim
off the excess edge of the gasket A (pic.2). The dimensions in picture 2 below refer to the distance
between the hole and the inside edge of the gasket. Do not fit the brackets shown in pic. 3 until the hob
has been set in place.
1)
2)
3)
NOTE:
Use all of the brackets supplied with the appliance to fasten it to the support structure.
4)
Use pipe-joint compound made for use with NATURAL and L.P.
gas. lf flexible metal connector is used, be certain tubing is not
kinked.
