Smeg MFF01, Руководство пользователя

Страница: 7 / 10

EN - 5
EN
USE (Fig. 1)
Recommendations for use
The result of the milk frother function
may be affected by the ingredients
used.
For a good result, it is recommend-
ed to use full-fat milk and to take it
from the fridge immediately before
pouring it into the carafe (2).
After a first heating cycle, wait for
the appliance to cool down before
starting another cycle.
Do not use the appliance without
liquids. Starting the appliance with-
out liquids could damage the pitch-
er.
Always fill up to the MIN level and
not over the MAX level; both indi-
cated inside the pitcher.
If the LED on the knob flashes and
three acoustic signals are repeated
twice, it means that the appliance
is in error status.
The error status is shown if the
pitcher or whisk are not present,
the pitcher is removed during
preparation or the cycle is started
with the pitcher empty.
In the first two cases, the cycle does
not start, while in the second two,
the cycle starts but stops after a few
seconds.
• Insert the plug into the power outlet.
• The LED (8) flashes, after approx. 120
seconds of inactivity the appliance goes to
stand-by and the LED switches off.
Heat or froth the milk
• Remove the lid (4) and pour cold milk into
the carafe (2), with reference to the level
indications etched inside the carafe itself.
• Re-mount the lid (4).
• Select the desired program by turning the
knob (7) in correspondence with the red
notch on the knob lock nut.
From the stand-by phase, the appli-
ance goes to processing phase.
• Press the START/STOP button (6) to start the
cycle, the LED (8) has a fixed light.
• An acoustic signal and the switching off of
the LED (8) indicate the end of the cycle.
• The cycle can be stopped before time by
pressing the START/STOP button (6).
• Remove the lid (4) gripping the lateral tabs.
• Remove the carafe (2) and pour the frothed
milk with the aid of a spoon.
The addition of sugar or sweetening
syrups (e.g. honey, agave juice or
maple syrup etc.) is recommended
at the end of the cycle.
Preparing chocolate
• Remove the lid (4) and pour the hot choc-
olate ingredients inside the pitcher (2),
referring to the level indicators printed inside
the pitcher and the suggestions indicated in
the Smeg recipe.
• Select the relative program and proceed
according to that described for milk.
During the working phase, it is
possible to remove the measuring
cap (5) to add powdered ingredi-
ents.
We recommend adding powdered
ingredients slowly and in small
quantities a few moments after the
Use