User instructions
35
To re-enable the acoustic device repeat the following procedure:
•
press down the
HALF LOAD (6)
button for a few seconds until the
bN
symbol appears on the
INFORMATION DISPLAY (7)
;
•
press the
HALF LOAD (6)
button again to enable to acoustic device (the symbol
bS
appears);
•
press the
START/STOP (5)
button twice to exit the set-up mode.
3.3 Washing
programs
The dishwasher is equipped with a control panel and an
INFORMATION DISPLAY
, described in
chapter "3. Description of the controls", from which it is possible to carry out all the power switch-
on, switch-off and programming operations.
Before starting a washing program make sure that:
•
The water supply tap is
open.
•
The
correct amount of detergent
has been added to the
dispenser
.
•
The baskets have been
correctly loaded.
•
The spray arms are able to
rotate freely
and without obstruction.
•
The dishwasher door is
securely closed
.
HALF LOAD WASH SETTING
This function is especially suitable for loads up to
6 place settings
and allows saving of water and
electricity. It is controlled by the
HALF LOAD
button
(6)
and allows washing in the upper basket
only.
IMPORTANT:
at the end of the program remember
to deactivate the function
to ensure the next
wash is not also carried out in half load mode
by mistake
.
A cutlery basket can be placed in the
upper basket
, while the
lower basket must be left empty.
CAUTION: there is no point in loading dishes and cutlery in the lower basket, since the jet of
water will only reach the upper basket.
CANCELLING THE CURRENT PROGRAM
To cancel the currently selected program, press the
START/STOP (5)
button for a few seconds,
until the active program appears on the
INFORMATION DISPLAY (7)
. At this point, to halt the
program in progress simultaneously press the
HALF LOAD (6)
button and the
START/STOP (5)
button. The
INFORMATION DISPLAY (7)
will show the letter
P
followed by a dash
(P-)
and the
dishwasher will automatically advance to the end of cycle.
CHANGING THE PROGRAM
To change the program, press and hold down the
START/STOP (5)
button for a few seconds, then
select the new program as described previously in the instructions; press the
START/STOP (5)
button again, holding it down for a few seconds.
