Smeg KD9X6-1, Инструкция по эксплуатации, Страница: 7 / 7

The manufacturer reserves the right to make changes and corrections to its products as it deems
necessary, without altering their basic characteristics.
• If your kitchen hood is made of stainless steel,
use proprietary cleaners mentioned in the
product instructions.
• If your kitchen hood is painted, use lukewarm
water and a neutral soap.
• Never use metallic scourers, nor abrasive or
corrosive products.
• Dry the kitchen hood using a cloth that does not
produce fibres.
• Do not use vapour cleaners.
• To remove the filters from their fittings, press
lightly on the locks and then pull them off.
• The metal filters can be cleaned by soaking
them in hot water with neutral detergent until the
fat dissolves and then rinsing them under the tap
or using special anti-grease products. They can
also be washed in a dishwasher. In this case,
it is advisable to stack them vertically to avoid
food residues to stick to them.
• Cleaning in a dishwasher may damage the
metallic surface (blackening it), although this will
not affect its fat retention capacity.
• Once clean, leave them to dry off and then fit
them onto the kitchen hood.
Problem solving
Proceed with the following checks before calling the Technical Service:
Active charcoal filters (Optional)
When exterior gas extraction is not possible, then the kitchen hood may be set to purify the air by recycling
it through active charcoal filters.
The active charcoal filters have an active life of between three to six months, depending on the individual
conditions of use. These filters cannot be washed nor regenerated. They must be replaced once their useful
life comes to an end.
GB
Problem Possible cause Solution
The kitchen hood does not
work.
The mains cable is not
connected to the network.
There is no current in the
network.
Connect the mains cable to the
network.
Provide current to the network.
The kitchen hood does
not extract sufficiently or
vibrates.
Filters are saturated with fat.
Obstruction in the air outlet.
Change or clean the active
charcoal and/or metal filters.
Remove the obstruction.
The lamps do not light up.
The lamps are blown
The lamps are slack.
Change the lamps.
Tighten the lamps.
Cleaning the hood body
Cleaning and maintenance
Cleaning the metal filters
Lamps
During cleaning and maintenance work, make
sure the safety instructions are complied with.
• Lamps included in this product are designed
exclusively for the illumination of the cooking
area.
• These lamps are not apt for lighting domestic
areas