Smeg KD120 series, Инструкция по эксплуатации, Страница: 2 / 12

EN
2
WARNING!

READ AND SAVE THESE INSTRUCTIONS.

Read the instructions carefully before installing and/or using the hood.

Before connecting, make sure that the mains voltage corresponds to the voltage on the
rating plate inside the hood. (see fig. 7)

Once you remove the appliance from its packaging make sure it is intact. If the product
is damaged, do not use it and contact the Smeg assistance network.

It is recommended that a qualified technician performs installation and adjustment
operations
.

The minimum distance between the cooker and the lower part of the hood must be
750mm for gas cookers and 650 mm for electric cookers.

Inspect and clean the filters thoroughly and in accordance with the intervals suggested
by the manufacturer.

UNPLUG OR DISCONNECT THE APPLIANCE FROM THE POWER SUPPLY
BEFORE SERVICING.

WARNING
– To Reduce Risk Of Fire Or Electric Shock, Do Not Use This Fan With Any
Solid-State Speed Control Device.

CAUTION
– For General Ventilating Use Only. Do Not Use For To Exhaust Hazardous
Or Explosive Materials And Vapors.

Do not cook or fry in a way that could result in flames being sucked into the hood and
causing a fire.

The hood surface can be cleaned with a damp cloth and a non-bleach liquid detergent.

Make sure the room is properly ventilated when using the hood and other gas
appliances at the same time.

Comply with the regulations on air discharge when operating the hood.

The extracted air must not be routed into a duct used to discharge fumes of
Gas-operated appliances.

This appliance must not be used by children without an adult supervision or
by disabled people without assistance.

THE MANUFACTURER CANNOT BE HELD RESPONSIBLE IF THE ABOVE
INSTRUCTIONS ARE NOT FOLLOWED.
OPERATION
This appliance has been designed to work as a DUCTING hood (evacuation of the air) or
RECYCLING hood (recycling of the filtered air).

DUCTED MODE: In order to use the hood in the ducted mode, connect the motor intake,
by means of a suitable ducting hose not less than 120mm diameter, directly to the external
fumes outlet.
Note: Remove any carbon filters.

RECIRCULATION MODE: If it is not possible to discharge fumes outside, the hood can
be used to filter and recycle the air. This way, air and fumes are filtered by the anti-odour
carbon filters and recirculated through the aerating grids on the sides of chimney.